Car Model Guide/ Mercedes-Benz/ C-Class/ S204/ C 180 CGI M271-EVO/ Issues

C 180 CGI M271-EVO, known issues

S204 · 2011–2014 · R2 Manageable

Recorded issues2

Walk-away0

Over €1,0000

Checkable at viewing0/2

Likely spend€1,200

Likely spend is the mid cost of every issue rated common or universal, added together, what an unmaintained example owes over the next few years, not a prediction for any one car. Worst case if everything here failed at once is €1,600, which isn't a realistic scenario but is a useful ceiling.

All issues, by system

Turbo & intake

Carbon buildup on intake valvesdirect injection€400–€700

Rough cold idle, slow throttle response, misfires, gradual loss of low-end response. Direct injection puts no fuel over the intake valves, so crankcase vapour deposits bake on undisturbed.

Check: Not visible without a borescope. Treat it as a service item that's due unless there's a receipt. It's not a fault, it's an unbudgeted maintenance cost.

Turbo & intakeuniversalNot detectable at viewingevidence: documented80–120k km

Transmission

7G-Tronic conductor plate and 13-pin connector leak (722.9)Mercedes 7G-Tronic seven-speed automatic (722.9)€400–€900

Harsh, delayed or jerky shifts, holding a gear then banging the next in, and limp mode, often with speed-sensor or gear-ratio fault codes. The speed sensors in the conductor plate (mechatronic) fail, and/or the external 13-pin connector leaks fluid that wicks up the wiring into the control unit. Early units are the most affected.

Check: Test-drive through every gear cold and warm. Scan the transmission, and pull the external 13-pin plug to check for fluid on the pins.

TransmissioncommonPartly detectableevidence: documented120–220k km

How to read this

Every issue is authored once against the part that actually carries it: the engine, the gearbox, the chassis or a shared component, and inherited by every variant that has that part. The badge next to each issue says where it comes from, so you can tell an M271-EVO problem from an E9x problem.

Evidence tiers. Manufacturer means a recall, technical bulletin or revised part number. Documented means workshop data or multiple independent sources. Reported means owner consensus with no hard confirmation, and never sets a risk level on its own.

← Back to the C 180 CGI M271-EVO